Quote:
Originally Posted by turboguzzi
the 2.4mm is the reading i get when i measure the gap in the crank i have.
look at the pic i posted again, these are feeler gauges of a total 2.4mm sliding between pin and bearing.
Hope i am not upsetting you when i'm trying to help....
|
Ah okay, I couldn't see it was 2.4mm on the picture.
Definitely not upsetting me.  I'm just confused. Looks like your timing gear is way higher than mine (or your bearing is way thinner), because I don't have any clearance between the bearing & timing gear either, but almost 1.5mm-2mm less clearance between crank & bearing.
Do you still have the crank?
Could you take a measurement like this?
It's from the back of the teeth to the start of the cutout. A bit weird I know but it's easy to measure and should be constant. Thanks
|