hi there i did the head bearings on my 1985 43f about 4 months ago it was the worst head bearing job ive done the ones on the bottom yoke were tricky i think i just weakened the surface with a dremel in a couple of places and hit it carefully with a hammer/drift/chisel until the bearing race cracked on the weak spots. the ones in the frame were a nightmare i put a small nick/groove in the frame where the bearing sits and used this with a good drift to get a good hold on the bearing this worked but was still v,v difficult . if the frame paint finish is not too inportant weld a small bolt or bar across the surface then just drift on the bolt, easy. if you do dremmel the frame, just enough to lightly touch the frame no more . the trick as seid before is slowly , slowly they will go, may be get a mate to help. good luck zigzag
|