A Tip on using a puller - tighten it really tight, and give the centre bolt a good bang with a very big steel hammer - that will often do it. It needs the pressure and the shock. Heat doesn't hurt either, but it's always been the big bang that does the job for me.
Trick with heat is temperature differential - get the OUTER part good and warm, and the SHAFT cold - so the outer needs heating quickly - NOT 15 minutes, and then an icy rag on the shaft for 10-15 seconds or so, with lots of pressure already on it, and then a good bang is the ultimate in my experience.
__________________
Grant Johnson
Seek, and ye shall find.
------------------------
Inspiring, Informing and Connecting travellers since 1997!
www.HorizonsUnlimited.com
|