You'd be surprised how much you can cram on, though I have had to add a 15mm alloy spacer on each end in order to fit the bark busters. This is only because (due to an arm injury) I have to run the front brake from the left bar using a hydraulic clutch master cylinder. As well as clutch and switchgear, it all gets a bit crowded! With a standard set up, I think it would all fit ok. I've attached a clearer pic. BTW, the serial no on my bars is 613, rather than the 513 which is listed by Renthal for Enduro Highs. I think they may be the Dakar bars, but I can't find a current listing for them.
Glad you like the pic - it was taken in Morocco last April, just out of Mhamid on CS's route MS7/8: an ideal place to play with an XT!
|