Nearly there and now I have a problem!
On the last lap: I am trying to fit the 2 triangular plates that join the rocker cover to the frame above it - there are 2 bolts on the frame with one through the top of the rocker cover, but they don't line up.
I can get all 3 bolts through one of the plates and then the two on the frame into the second plate; at this point the bottom of the second plate is mis-aligned with it's bolt by about 1/2 of the bolt thickness.
I remember that these bolts were very tight (not just the nuts which have quite a high torque value anyway) when I removed them; it is as if the engine has moved a bit when they were released!!!
So, has anyone got any suggestions while I tear my hair out?!!
Ta,
Dave
__________________
Dave
|