HI all,
New here but faced with similar 24V/12V shenanigans on an ARB CKMTA24 compressor install.
In my case, it's going in a boat, with only 24V supply.
I'm therefore looking to do what ALU did, and replace the 12V control components with 24V versions.
So far I've ordered 2 x 24V relay replacements, a 24V cooling fan, and a 24V rated on/off switch.
My question is, does the pressure switch also need swapping out for a 24V version? Or will this be fine....the only marking on the side is 20A (and the max/min pressure)...no mention of voltage.
And what about the diodes within the loom, do I need to swap those? I can't find any detail on the rating of those.
Hope someone can help!
|