Jimmy101,
Am in Gulgong...
No real need for pictures of the install, but it works like this...
Run a fused wire from Battery +ve along the existing wiring loom up to the heatlight region, this wire goes to the supply side of the relay. Next you need to tap into both the low and high beam power feed wires behind the headlight (before the HID conversion wiring) so that the mod works even after the HID is removed. The switched battery power from the relay is wired to the LOW beam power feed wire. The high beam power feed wire is taken to the relay and used as the exciter wire to pull the relay in when the high beam is switched on. All that is left to do is earth the remaining leg of the relay. Doing it by numbers is simple enough:
pin 87 to low beam feed
pin 30 to fused battery +ve
pin 85 to ground
pin 86 to high beam feed
Relay just gets cable tied to the headlight support bracket and wiring neatly taped/tied up.
Cheers
Ian
|