Lol  hey
Notice at the shock location... it is exactly 55mm (center to center screws) towards the back of the frame on the small gap where the top of the air box holds onto the frame (two holes on a strip of metal that is welded onto both sides of the frame).
The shock, with my YZ250 front forks, is spot on with me on the bike lol! the seat height increases a bit matching the 5cm increase on the front and I like it lol
The kickstand will have to be increased by about 15cm guesstimate..I didn't actually measure it... or get a MX one with similar needed length that can be fitted..
Stock air box: I got to check if there is enough clearance for the rear shock but for now I can only say that it has to go back about 5cm from the top mounting holes...because of this the right seat plastic panel looses it's mounting hole..
Since I want to make a fiberglass airbox-battery-CDI (or TCI?) holder and a LowerMudguard-taillight/license plate holder I'm not really worried about the stock airbox..
The "worst" part of all this I guess will probably be finding the correct carb settings..
Vando
|