xt600 magneto wiring
 

hi there im new to the forum so i hope someone may be able to help i have a kickstart xt600 motor not sure which year? maybe 86-88? which i would like help in identifying the wiring from the magneto/stator if any one can break down where each wire goes, or what its for? im familar with the 3 wires going into the regulator but the rest im not to sure..

the wires are

solid brown
solid red

2x solid white in a 2 pin plug

and then the 3 pin plug that goes to the voltage regulator

ideally the i need to know where the 2 solid white wires go and there function and does it matter which way they go around? and what the function of the brown and red wires are? im aware they go to the cdi but would like to know what there for?


the bike is for offroad use only and only has a headlight and tailight so wiring is going to be absolutely minimal and battery free ( if possible?)

thanks,

:)

Here is a wiring diagram

http://i1302.photobucket.com/albums/...psf82newiu.png

thank you!!!! so with the side stand switch i can earth it out?

To disable the side stand switch, follow the wiring up towards the main wiring harness. You will find the bullet connectors. Unplug the side stand wiring and plug the two wires going to the main harness together. This fakes the CDI into thinking the side stand is up all the time. The side stand switch can go intermittent and even if the side stand is up, it may give an indication that it is down and kill the engine or make it run weird.