where to get 12v for a relay on xt600
 

Hi

Im going to install symtec warmers and I have bought a relay to control when the symtec gets any power.

The problem is where should I give the relay its power from? I thought about the headlight cable, so that the warmers wont work unless the bike is running and the lights are on.

But does anyone know a smarter place to take 12v power for the relay from?

I find the live wire up to the front brake light switch is a good take off point it means that you will have power any time the ignition is on......

:thumbup1:

If you are going to put the relay under your seat you could use the same feed on the rear brake switch.

Use a piggy-back lucar connector, then you don't have to start cutting into the wiring either.