CDI and Relay ...
 

Hello,

My electronics knowledge is basics so here are the problems

I rebuilt my Xt 600 e 1998...Found a loom which seems to come from a 1999. The relay connector from the loom is a 3 pin with a positive wire ?but the 1998 relay has 2 pin only to the switch

And I have no connector between the relay 4 pin I need to get and the loom so need to work on that and plug the wires on the right pin onto the relay.

Then I guess the10 amp fuse is now located on the relay itself as i cant see it elsewhwere on the loom.

Finally i wonder if the CDI from a 1998 bike will work with later loom 1999 onward even if it plug perfectly...

Photo may be easier....but dont have the bike now...Hope this was clear.

Thanks

first of all, it's a TCI, not CDI in those model years.
doesnt sound a common mod to switch looms, so doubt if youll get an immediate answer, best download both wiring diagrams and have someone into electronics figure out the logic.
never seen a fuse inside a relay.
and a 2 pin relay doesnt sound like a relay.... are you surre it's not the trun signal blinker unit?

Hi,
Ok so say it s aTCI.

Well the loom match all connector. I already plug tbe switch relay and shortcut the sidestand switch no problem

The previous relay has a 2 pin connector to the loom and 1 for the positive and 1 forthe ground.

The new relay has indeed a fuse on it. With 4 Pin then 2 more if you consider the positive to the battery and the one wire to the starter.

Anyother answer from someone who know the XT?

Thanks

well, have fun checking these out, maybe you'll find an answer



https://www.xt600.de/xt_werkstatt/_t...plan/index.htm


you welcome! :)