Horizons Unlimited - The HUBB

Horizons Unlimited - The HUBB (https://www.horizonsunlimited.com/hubb/)
-   BMW Tech (https://www.horizonsunlimited.com/hubb/bmw-tech/)
-   -   BMW CANbus auxiliary power fuse panel (https://www.horizonsunlimited.com/hubb/bmw-tech/bmw-canbus-auxiliary-power-fuse-80029)

magellan 11 Jan 2015 19:59

BMW CANbus auxiliary power fuse panel
 
I'm looking for the best auxiliary power fuse panel for my 2015 R1200GSA. I want to install accessories and have them, in most cases but not all switch off when the ignition is off.

Also I would like to see a "how to" video for installation of the fuse panel and some of the most obvious accessories.

Thank you all

brbo 11 Jan 2015 22:18

Fuzeblocks FZ1
 
This panel is very popular I know in NA and with BMW groups, not cheap - however I installed one for a buddy - great quality, 30A Relay all built into the one box, simply moving your fuse can change the Acc. to be switched or not - 3 simple wires to connect plus # of acc. you have.. and much smaller than the pictures look also...

FUZEBLOCKS.COM


http://www.fuzeblocks.com/images/fullsize/001_fs.jpg
http://www.fuzeblocks.com/images/fullsize/010_fs.jpg

MEZ 31 Jan 2015 16:59

Zen Overland Fusebox
 
Hello mate, have a look at this one, might be just what your after..


Zen Overland - FuseBox

UKRoadrunner 21 Feb 2015 12:01

If you don't mind spending a few quid then here's one CanBus friendly gizmo that ticks just about every box you can think of in comparison to a more conventional fuse box set up:

PDM60 | Rowe Electronics

My last bike, which unfortunately was written off by some muppet car driver last year had a variety of gizmos attached which I'd manage to bodge up over the years. To the extent that if you took a fairing panel off it looked like some jackdaw had built a cozy nest inside.

In anticipation of getting a new bike I splashed out on one of these PDM60 modules as it seemed a logical solution to not only minimizing the wiring, but it also doesn't need any fuses. You can also programme (via a USB lead) what each circuit is rated to in increments of 1 Amp, and you can also add in delays to start up and power down of every circuit, anything up to 10 minutes after you've switched the bike off.

This means I should be able to make a nice neat job of adding power to my farkles from the word go. So far I'm adding the following items, all controlled from this unit:

1. LED fog lights
2. Main sat nav
3. *Powered (split) feed to both Mobile phone & 2nd sat nav (for IBA events)
4. Front mounted accident camera
5. Spare - to be used for future heated clothing
6. Rear LED fog light (why don't manufacturers fit these?)

*Using Ultimate Addons powered waterproof phone case & associated wiring:
Motorcycle Accessories


All times are GMT +1. The time now is 04:35.


vB.Sponsors