Go Back   Horizons Unlimited - The HUBB > Technical, Bike forums > Yamaha Tech
Yamaha Tech Originally the Yamaha XT600 Tech Forum, due to demand it now includes all Yamaha's technical / mechanical / repair / preparation questions.
Photo by Daniel Rintz, Himba children, Namibia

The only impossible journey
is the one
you never begin

Photo by Daniel Rintz,
Himba children, Namibia



Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 1 Sep 2012
Registered Users
New on the HUBB
 
Join Date: Sep 2012
Posts: 14
XT600 34L noisy motor and poor brakes.

Hi, Born again biker here (sort-of) been out of biking for a LONG time and bought a 1983 Yam XT600 34L Tenere basket case a few months back, bit of a spur-of-the-moment thing.
I have pretty much got it back together and running now but it sounds very 'tappety' to me, have tried checking/adjusting the clearances several times but it never sounds any better.
So took the head off, everything looked OK, couldn't feel any sign of little end play but was a bit surprised to see that the cam shaft does not have any kind of bearing, I couldn't find any play in it but wondered if this had ever been know to cause problems.
Or is it just me, are they all a bit noisy on the top end?

I'm also having trouble getting, what I would call, a decent front brake, put repair kits in the master and calliper and must have put about a litre of fluid through it (no sign of air).
Reply With Quote
  #2  
Old 1 Sep 2012
BlackDogZulu's Avatar
Registered Users
Veteran HUBBer
 
Join Date: Oct 2008
Location: West Wales, UK
Posts: 753
Hard to diagnose sounds over the internet ...

Depends what you are comparing it to. If your last bike was a Jap multi, then the XT will sound like a bag of spanners. There is a fair amount of mechanical noise, which goes with the territory of an air-cooled single. If the valve clearances are OK, and there is no obvious play in the cams or small end, then it might just be 'they are all like that, Sir'.

The front brake on mine has never been brilliant, even with a good s/h caliper and new seal kit. It's a relatively small single disc, and was designed to be a good brake for trail riding, which is not the same as a good brake for road use. I'd say it was 'adequate', no more. Good in town traffic, not so good on faster roads.

Probably your best bet would be to find someone local with a similar bike and get him/her to have a look at it. Rest assured that even with a noisy top end, these bikes go on forever.
__________________
2006 XT660R daily ride, 1994 XT600E about to be reborn, Blog: http://goingfastgettingnowhere.blogspot.com/
Reply With Quote
  #3  
Old 2 Sep 2012
Registered Users
New on the HUBB
 
Join Date: Sep 2012
Posts: 14
Thanks, I'll rest assured then, it might not be too bad with a helmet on but it does sound noisy in the garage. I have no experience of modern bikes, only multi I ever had was an A65 Beezer, I did try asking a local mechanic (old timer) but all I got out of him was "a rattly tappet is a happy tappet"
Reply With Quote
  #4  
Old 3 Sep 2012
Registered Users
HUBB regular
 
Join Date: May 2007
Location: Victoria, Australia
Posts: 80
Hi 34Lima

I think we have just got used to the modern liquid cooled bikes where you can't hear the tappets! If you think they are bad wait 'till you get it rebored and stick a forged piston in there. When it's cold the noise is frightening!!

As for the front brake, like BDZ says not really that good (make you look further ahead though!!) I got a better "feel" from mine by fitting a braided front line, otherwise they can feel very spongy.
Reply With Quote
  #5  
Old 3 Sep 2012
Registered Users
New on the HUBB
 
Join Date: Sep 2012
Posts: 14
Fortunately the bore looked pretty good when I had the top off, no sign of a 'lip', don't know if the speedo is right but it only has 10K miles on it but if thats right it's been a mis-treated 10K.

I think it possibly is the spongy feel as much as anything that is my problem with the brake, it has a pipe on with metal braiding and a plastic sleeve on the outside, are there different types about?
Reply With Quote
  #6  
Old 3 Sep 2012
BlackDogZulu's Avatar
Registered Users
Veteran HUBBer
 
Join Date: Oct 2008
Location: West Wales, UK
Posts: 753
Quote:
Originally Posted by Chrispy View Post
As for the front brake, like BDZ says not really that good (make you look further ahead though!!)
That's right - you learn to 'ride round it'. I don't regard my brakes as in any way dangerous - just suitable for the bike's intended use, and I don't ride in a way that demands instant hitting-a-wall type braking. To be fair, if you are looking for a brake that will stand the bike on its nose on dry tarmac, you're probably on the wrong bike.
__________________
2006 XT660R daily ride, 1994 XT600E about to be reborn, Blog: http://goingfastgettingnowhere.blogspot.com/
Reply With Quote
  #7  
Old 3 Sep 2012
Registered Users
New on the HUBB
 
Join Date: Sep 2012
Posts: 14
Definitely not wanting to do stoppies! I suppose I have just got used to modern car brakes so the spongy feel and being able to pull the lever almost back to the grip concerned me a bit.
Reply With Quote
  #8  
Old 3 Sep 2012
Registered Users
HUBB regular
 
Join Date: May 2007
Location: Victoria, Australia
Posts: 80
Sounds like you already have a braided line on the front. The original was the old black rubber type, and when they got old you could sometimes see them flexing when you pulled on the lever.

If the lever is coming all the way back to the grip, and it feels spongy, then it sounds like you still have air in the system. It's a very long line and I had the devils own job getting all the air out. I stood there for about an hour flicking the line and watching small bubbles rise! Back to the garage with a time.....
Reply With Quote
  #9  
Old 4 Sep 2012
BlackDogZulu's Avatar
Registered Users
Veteran HUBBer
 
Join Date: Oct 2008
Location: West Wales, UK
Posts: 753
Quote:
Originally Posted by 34Lima View Post
Definitely not wanting to do stoppies! I suppose I have just got used to modern car brakes so the spongy feel and being able to pull the lever almost back to the grip concerned me a bit.
Heh. Every modern car (i.e. less than a couple of years old) I have driven lately has had brakes that are far too sharp and sudden for me. If you're comparing the XT's brakes to that, no wonder you are concerned

I guess that on full braking power, the lever comes back most of the way to the bar and the suspension compresses 2/3 of the travel. It stops quickly but not suddenly, if that makes sense. I've accepted that's as good as it gets and I ride accordingly. Don't forget that the lever is adjustable. If it's coming back to the bar, it might just need the little screw and locknut moving slightly. A small adjustment here makes a lot of difference.
__________________
2006 XT660R daily ride, 1994 XT600E about to be reborn, Blog: http://goingfastgettingnowhere.blogspot.com/
Reply With Quote
  #10  
Old 5 Sep 2012
Registered Users
Veteran HUBBer
 
Join Date: Dec 2010
Posts: 114
34l

My xt I got last year sounded a little more clunky than it should of,I checked valve clearances and were fine,so bit the bullet and took top end of to find it had a pretty badly worn small end bush in the rod and looking at piston may possibly have been run out of oil at sometime on its life..
On stripping engine I found the blanking plug in the right hand side of gearbox output shaft had fallen out,hence oil from the pressurised gallery just pouring out the end of shaft..
A Conrod,piston,bearings and a ball bearing welded in end of shaft later all was good,and I've gone from thinking what a piece of junk I bought to actual quite liking it,and doing two fairly big trips on it.
The front brake can seem a bit spongy,I would just bleed it with a syringe from the bottom up then just ride it...my front brake got a lot better with a little use,it's as good as one would want given the front tyre on the things now..
Stick at it and it will be a good bike.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 Registered Users and/or Members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


 
 

Announcements

Thinking about traveling? Not sure about the whole thing? Watch the HU Achievable Dream Video Trailers and then get ALL the information you need to get inspired and learn how to travel anywhere in the world!

Have YOU ever wondered who has ridden around the world? We did too - and now here's the list of Circumnavigators!
Check it out now
, and add your information if we didn't find you.

Next HU Eventscalendar

HU Event and other updates on the HUBB Forum "Traveller's Advisories" thread.
ALL Dates subject to change.

2024:

Add yourself to the Updates List for each event!

Questions about an event? Ask here

HUBBUK: info

See all event details

 
World's most listened to Adventure Motorbike Show!
Check the RAW segments; Grant, your HU host is on every month!
Episodes below to listen to while you, err, pretend to do something or other...

2020 Edition of Chris Scott's Adventure Motorcycling Handbook.

2020 Edition of Chris Scott's Adventure Motorcycling Handbook.

"Ultimate global guide for red-blooded bikers planning overseas exploration. Covers choice & preparation of best bike, shipping overseas, baggage design, riding techniques, travel health, visas, documentation, safety and useful addresses." Recommended. (Grant)



Ripcord Rescue Travel Insurance.

Ripcord Rescue Travel Insurance™ combines into a single integrated program the best evacuation and rescue with the premier travel insurance coverages designed for adventurers.

Led by special operations veterans, Stanford Medicine affiliated physicians, paramedics and other travel experts, Ripcord is perfect for adventure seekers, climbers, skiers, sports enthusiasts, hunters, international travelers, humanitarian efforts, expeditions and more.

Ripcord travel protection is now available for ALL nationalities, and travel is covered on motorcycles of all sizes!


 

What others say about HU...

"This site is the BIBLE for international bike travelers." Greg, Australia

"Thank you! The web site, The travels, The insight, The inspiration, Everything, just thanks." Colin, UK

"My friend and I are planning a trip from Singapore to England... We found (the HU) site invaluable as an aid to planning and have based a lot of our purchases (bikes, riding gear, etc.) on what we have learned from this site." Phil, Australia

"I for one always had an adventurous spirit, but you and Susan lit the fire for my trip and I'll be forever grateful for what you two do to inspire others to just do it." Brent, USA

"Your website is a mecca of valuable information and the (video) series is informative, entertaining, and inspiring!" Jennifer, Canada

"Your worldwide organisation and events are the Go To places to for all serious touring and aspiring touring bikers." Trevor, South Africa

"This is the answer to all my questions." Haydn, Australia

"Keep going the excellent work you are doing for Horizons Unlimited - I love it!" Thomas, Germany

Lots more comments here!



Five books by Graham Field!

Diaries of a compulsive traveller
by Graham Field
Book, eBook, Audiobook

"A compelling, honest, inspiring and entertaining writing style with a built-in feel-good factor" Get them NOW from the authors' website and Amazon.com, Amazon.ca, Amazon.co.uk.



Back Road Map Books and Backroad GPS Maps for all of Canada - a must have!

New to Horizons Unlimited?

New to motorcycle travelling? New to the HU site? Confused? Too many options? It's really very simple - just 4 easy steps!

Horizons Unlimited was founded in 1997 by Grant and Susan Johnson following their journey around the world on a BMW R80G/S.

Susan and Grant Johnson Read more about Grant & Susan's story

Membership - help keep us going!

Horizons Unlimited is not a big multi-national company, just two people who love motorcycle travel and have grown what started as a hobby in 1997 into a full time job (usually 8-10 hours per day and 7 days a week) and a labour of love. To keep it going and a roof over our heads, we run events all over the world with the help of volunteers; we sell inspirational and informative DVDs; we have a few selected advertisers; and we make a small amount from memberships.

You don't have to be a Member to come to an HU meeting, access the website, or ask questions on the HUBB. What you get for your membership contribution is our sincere gratitude, good karma and knowing that you're helping to keep the motorcycle travel dream alive. Contributing Members and Gold Members do get additional features on the HUBB. Here's a list of all the Member benefits on the HUBB.




All times are GMT +1. The time now is 23:41.