Windblown: Adventure 'lip' screen wanted
 

Does anyone have for sale or know where to get an old screen/fairing for a pre-2000 640 Adventure with the lip design? Even the top few inches of one would help!

Xtian

I made one for my '02 Adventure. Find a suitable piece of plastic, tape it in place. Use a heat gun to get it hot and mold it. I used a piece of sheet plastic that was used as a stiffener in an old luggage case. It was thin enough that I could trim it with scissors. Good at 90 mph. Applied with black duck tape, covered part with sticky shelf paper, actually a thin vinyl. I molded a flipped lip at the top.
It looks good.
Bill.

Any pixs?...........................................

pics
 

I am so stupid with the computer and camera. I will try this weekend.
Bill

Here'a a picture
 

Not a great picture but it gives an idea.
I have to admit it is held in place by black Duct tape.
The plastic is very thin but the whole thing works very well

http://i95.photobucket.com/albums/l1...n/IMG_4811.jpg



http://i95.photobucket.com/albums/l1...n/IMG_4809.jpg



Hope this helps.
Bill.

Many Thanks Bill!

Here's the whole bike
 

'02 Adventure.
The tires are gone.
It is lowered 4 inches, 100mm using internal suspension changes,
and linkage arms.
Bill

http://i95.photobucket.com/albums/l1...n/IMG_4805.jpg

Found this on the UKGSER site, hope it helps. Dont know if its been sold yet.

http://www.ukgser.com/forums/showthread.php?t=93873

Ian

Check this. http://www.advrider.com/forums/showt...ghlight=cheapo

Worked greatr on my 640