Horizons Unlimited - The HUBB

Horizons Unlimited - The HUBB (https://www.horizonsunlimited.com/hubb/)
-   BMW Tech (https://www.horizonsunlimited.com/hubb/bmw-tech/)
-   -   Airhead valves (https://www.horizonsunlimited.com/hubb/bmw-tech/airhead-valves-32519)

Jiris 21 Jan 2008 18:40

Airhead valves
 
Hello all,
I'm going to change push rod tubes seals on my R100GS and at the same time want to inspect cylinder heads. The bike has 115000kms on the clock (it might be more, I own it since 70000), engine takes little oil, I'd say less than 0.1l per 1000kms and it isn't noisier than other airheads I've heard. The thing I'd like to know is if I should have valves and guides replaced and seats recut on the bike with such a mileage even if they are in their wear limits. I'm preparing the bike for a long trip and want to have everything 100%.

Please advise

AliBaba 21 Jan 2008 18:59

0.1 l oil per 1000 km is pretty good for an engine of that mileage.

If you prepare the bike for a long run tour I would have overhauled the cylinder heads. I did it at 150kkm and it was needed.

It might be smart to check the pistons and rings to. My rings and piston (R80GS) were good at 150 kkm but at 180 kkm they where far outside the tolerance – but the engine was running nice.

Timing chain and clutch should normally last a lot longer the 115kkm but it might be smart to change them if they are original.

Vaufi 21 Jan 2008 20:57

While the engine is open, check the main bearings in the crankshaft as well. When I had to exchange the seals for the push-rods I checked my bank account and had the pistons & con-rods balanced on my R80GS. Jeez, what a difference! The engine runs so nice & smooth now.

Hans

oldbmw 21 Jan 2008 21:25

I would not take apart a good running engine to do this, but seeing that you have the valves out, i would fit new exhaust valves keeping everthing else that was in specification. If you change the guides, you will have to recut the seats. I would avoid removing metal for as long as possible.

Jiris 22 Jan 2008 20:56

Thank you guys for your input.
I agree with oldbmw. I don't like to remove any metal unless it is necessary. I'll take a look at seats and I'll inspect guides using method described in repair manual. If they both look OK I'll probably replace only valves as a precaution against split exhaust valve head. I've heard or read warnings this may happen on the engines with high mileage. Is there any reason why I shouldn't fit new valves into old guides if they are in good shape?
BTW does anyone know new valve stem diameter? I know they are stated to be 8MM but I'm guessing they are slightly smaller. 7.98?

dc lindberg 25 Sep 2008 20:15

How did it go ?
What did you chose to do ?

Ever heard of metal fatigue ?... get new valves!


All times are GMT +1. The time now is 22:29.


vB.Sponsors